ihmsa forums

help me! just purchased a DW supermag, and now i am in dire need of ammo or brass. anyone have any they would like to sell? thanks

I would suggest cutting down 30-30 brass. Works great. Try C4HD.com. Their product number is 375USA. Three die set is $83.20. Taper crimp die is $48.88 and the trim die to make out of 30-30 brass is also $48.88. Only other company I know of that made 375SM dies is Redding and they will run much higher. I have used CH4D dies and they work great. The 375SM is a great cast bullet cartridge. I have owned two guns in that caliber but mine were the Eldorado revolvers.

Fingers worked faster than my brain. Company is CH4D NOT C4HD. Time for bed!!!

260 Striker wrote:I would suggest cutting down 30-30 brass. Works great. Try C4HD.com. Their product number is 375USA. Three die set is $83.20. Taper crimp die is $48.88 and the trim die to make out of 30-30 brass is also $48.88. Only other company I know of that made 375SM dies is Redding and they will run much higher. I have used CH4D dies and they work great. The 375SM is a great cast bullet cartridge. I have owned two guns in that caliber but mine were the Eldorado revolvers.

don't think i will shoot this enough to warrant die purchase. found a company that will take my brass and reload it for little more then $1/round. think i will go that route

I have some 375 brass made from 30-30. If interested call 509-991-0091.
#4704
Don

$1 per round. I would be afraid to pull the trigger on that ammo even if I hit what I was aiming at. After 100 rounds of ammo you would have your dies paid for. If you are going to use it for IHMSA silhouette use, you can go through 100 rounds at one match. Good cartridge.

phone call coming Ron. don't see this being more then a safe queen with occaisional range trips. i shoot my 357 supermag and 445 regularly.

Ron,

thanks for the brass, found some heads, now will grab dies and get these loaded!