ISO Front sight Rem XP-100 or scope mounting
Posted: Thu Oct 28, 2021 10:59 am
Guys-Gals,
Looking for a front sight that will fit an older barrel marked as 7 x 51 made back in the days by Top Hat Gunsmithing -- I reached out to my local buddies and they helped me to deduce that it most likely was made by them. I did a measurement and the hole spacing center to center is 9/16 inch. I could use either a globe setup or a basic ramp with blade that will fit the hole spacing. I could also use if someone could help me find a scope mounting base like the 2 piece plates to use a weaver scope base.
Take a look at your old parts and pieces and let me know if you have the necessary parts to help me get this good ole XP back in to slamming down some steel again.
Steve 7771
Looking for a front sight that will fit an older barrel marked as 7 x 51 made back in the days by Top Hat Gunsmithing -- I reached out to my local buddies and they helped me to deduce that it most likely was made by them. I did a measurement and the hole spacing center to center is 9/16 inch. I could use either a globe setup or a basic ramp with blade that will fit the hole spacing. I could also use if someone could help me find a scope mounting base like the 2 piece plates to use a weaver scope base.
Take a look at your old parts and pieces and let me know if you have the necessary parts to help me get this good ole XP back in to slamming down some steel again.
Steve 7771