ihmsa forums

Just thought I would post some info on the recently suppied / bought mold from NOE over on the Cast Boolit site.
I needed a nose-rider design along the lines of the RCBS 145 gr which I have been shooting in my XP 7BR. The new mold is a five banger and it sure drops boolits fast, one banks worth at each opening. It has a larger metplat than the RCBS one, hence the "hunter" name as many on that board wanted a hunting boolit.
I shot two matches recently and ended up with two 39/40's. Both misses in each match were definitely caused by the nut behind the butt.
I used the load of V V N140 I use with the RCBS boolit. Very little difference in POI, not enough to even need to dial on.
Well worth trying if you can get a mold. Peter

Peter,

I am also using N-140 but with the RCBS bore rider 145 grain bullet. I use 29.5 grains in my 10" MOA Chambered in 7BR with Remington 7 1/2 Primers & Remington cases.

What pistol are you using & what is it chambered in?

Steve W.

19 Turkeys wrote:Peter,

I am also using N-140 but with the RCBS bore rider 145 grain bullet. I use 29.5 grains in my 10" MOA Chambered in 7BR with Remington 7 1/2 Primers & Remington cases.

What pistol are you using & what is it chambered in?

Steve W.

Hi Steve

XP100 7BR, in the brown zytell stock. i have been using the 145gr RCBS for many years with 28 grains of N140, Fed SR primers.
I wanted a five banger mold to speed up the casting process and the Hunter is similiar but with a wider metplat.
I have a clone of the RCBS 357cal 200gr mold on order which is an exact copy so that will again speed up the casting for my FA 357.
I am about to get (two more sleeps) my FA Single shot 15" 7BR so hopefully the Hunter boolit will also fit and shoot well in that.

19 Turkeys wrote:Peter,

I am also using N-140 but with the RCBS bore rider 145 grain bullet. I use 29.5 grains in my 10" MOA Chambered in 7BR with Remington 7 1/2 Primers & Remington cases.

What pistol are you using & what is it chambered in?

Steve W.

Steve
What velocity are you getting with this load. Sounds like a pretty potent load
Melvin

They're doing a rerun of this mold over on CB. I put in for a 3 banger with one hollow point. I'm planning to use it in a 7 TCU for steel and hunting.