Adjusting exemplar front sight
- 7br
- Spotter
- Posts: 95
- Joined: Fri May 06, 2011 3:48 pm
- IHMSA Member#: 49783
- Location: Bolivar, Missouri
Adjusting exemplar front sight
I purchased an adaptor block and a ISGW rear sight. Now my anschutz is hitting about 12" high at 25yards with the sight bottomed out. Is there an easy way to raise the factory front sight?
- Richard Pickering
- Class B
- Posts: 304
- Joined: Sun Feb 06, 2011 10:56 am
- IHMSA Member#: 5905
- Location: Stone Mountain, Ga
Re: Adjusting exemplar front sight
If the addition of an adapter block raised the rear sight I believe you need to find a way to raise your front the same amount, or replace it. This will reestablish the relationship. I removed the original sights from mine years ago because the rear notch was just too small. I used a hooded front with the adjustable post. rp
I have served as assistant match director, Southern Silhouette club, 1980s. Also, the Griffin Gun Club for Silhouette during the 1990s, to about 2005. For a short period I authored the ''Cast Bullet'' section of The IHMSA News. Joined IHMSA March 1979.