I am looking at manufacturing a set of ½ scale targets and have a question about the feet for the pigs.
The website lists the feet at 2” x 4” but this is too small to fit both feet in 1 foot, but the legs are too close to put 2 feet in the centre of each leg. Just wondering if you could please clarify how to configure the feet.
Thanks

The feet should almost touch each other in the middle. If I remember correctly. When we built our field pistol targets the welder used a solid piece then cut in half after wlding to target.

1/2 scale Pig's feet? Heck, they sell them around here in most country stores. They are in a big jar on the counter. They are pickled.


Mike