WTB Ruger silhouette sights

[jcunclejoe]

Hello, I'm looking for a set of silhouette sights for a Ruger.

I have a new, to me, Ruger 32 H&R with the 9 1/2" barrel. I'd love to give it a run with good sights in Field Pistol.

Thank you.

Joe
jcunclejoe@aol.com

[WA_SHTR+44M]

Hey Joe, Do you know if the sights from a Super Blackhawk will fit your Ruger?
If so I will make a contact with a freind of mine that has a set of Bomar sights.

Steve B

[260 Striker]

Steve, Barrel diameters are probably way off. RSB has a bull barrel and bigger diameter. If Joe is not interested please pm me about your friend's sights.

[jcunclejoe]

The rear sight is the most important one and I'm pretty certain Ruger uses the same rear sight on almost everything.

I did ask Steve to check on it for me as I am interested.

Thank you guys.

Joe

[braud357]

Just a FYI - when these sight sets were available they only made one kind - I installed a set on a Single Six with no problems. yes, barrel contour was a bit off, but the globe front mounted square. In fact, my brother Charlie has a Single Six with this set-up. Better grab it quick - they are virtually non-existent today !

[hardtoseeovergut]

So true, I've looked for a couple of years. Even tried South Africa where a company used to make them to no avail

[Hosspower]

I had 260strikers old SBH. He had a nice Bowen rear sight on it. I put a hooded contender front sight on. It fit nice but I had to take the front post down quite a ways. I sold it to my brother and he has the original ramp back on it.

The setup I had wouldn't meet production requirements though.

[jcunclejoe]

Sight set found.
Thank you Steve B.

Joe

[260 Striker]

WA_SHTR+44M, If Joe didn't get his Ruger sights from your friend I would still be interested.
Lynn at shultza@watchtv.net
Thanks!

[WA_SHTR+44M]

Picked up the Bomar set and shipped it to Joe today. Nice set of sights too.