ok, a new project..
anybody know where I can get a Rear grip stock that I can fit to a wichita silhouette pistol? probably will need a stock that is not inletted or partial. I will be fitting a Rem 700 trigger in it and Pillar bedding the stock.
I am mainly fed up with the center grip trigger on the WSP. just too unreliable.
any suggestions will be greatly appreciated.
forgot. the WSP will accept a Rem 700 trigger but the Mk40 will not.
wichita silhouette pistol
- nutcase
- Site Admin
- Posts: 929
- Joined: Sat Jul 09, 2011 4:44 pm
- IHMSA Member#: 42084
- Location: Yuma, AZ
wichita silhouette pistol
Daniel Hagerty
IHMSA # 42084L
IHMSA News Editor - 2015-2017
.22 records Coordinator - Present
CA State Director - 2015-2019
Match Director, Stockton Silhouette club 1990-1995
NRA Patriot Endowment Life Member
IHMSA # 42084L
IHMSA News Editor - 2015-2017
.22 records Coordinator - Present
CA State Director - 2015-2019
Match Director, Stockton Silhouette club 1990-1995
NRA Patriot Endowment Life Member
- nutcase
- Site Admin
- Posts: 929
- Joined: Sat Jul 09, 2011 4:44 pm
- IHMSA Member#: 42084
- Location: Yuma, AZ
Re: wichita silhouette pistol
Thanks to BruceW for the Stock and a Trigger! it fits almost perfect and will require very little fitting!
Daniel Hagerty
IHMSA # 42084L
IHMSA News Editor - 2015-2017
.22 records Coordinator - Present
CA State Director - 2015-2019
Match Director, Stockton Silhouette club 1990-1995
NRA Patriot Endowment Life Member
IHMSA # 42084L
IHMSA News Editor - 2015-2017
.22 records Coordinator - Present
CA State Director - 2015-2019
Match Director, Stockton Silhouette club 1990-1995
NRA Patriot Endowment Life Member